Skip to content
15% off your first order15% off your first order

Reconstitution calculator. Three numbers, one clear answer.

Draw to

17units

on a U-100 insulin syringe · 0.17 mL

Concentration
15.0 mg/mL
Measures per vial
12
Peptide in vialVialPrinted on the vial
Water addedWater
Amount= 2,500 mcg
Bacteriostatic water$19 · For reconstitution

A planning aid to use alongside the instructions included with your CoreX protocol. Not medical advice.

Mix the vialFive steps, every time.
  1. 1

    Sanitize everything

    Wipe the peptide vial stopper and the BAC water vial with a fresh alcohol swab. Let both air-dry for a few seconds before you draw.

  2. 2

    Draw your BAC water

    Using a syringe, pull the exact amount of bacteriostatic water you entered above. Air bubbles are fine at this stage — you only need the volume.

  3. 3

    Add it down the wall

    Insert the needle at an angle and let the water run slowly down the inside glass wall of the peptide vial. Never blast it directly onto the powder.

  4. 4

    Swirl, don’t shake

    Roll the vial gently between your fingers until the powder fully dissolves. Shaking foams and can damage the peptide — patience beats force.

  5. 5

    Inspect before use

    The solution should be clear and particle-free. Store reconstituted vials refrigerated and draw your dose with a fresh U-100 insulin syringe.

Products are provided for research purposes and are not intended to diagnose, treat, cure, or prevent any disease. Check every calculation against the instructions included with your order.